Ranger-Style Hat Band

Leather Hatband Details

Materials: Made with ONLY Hermann Oak leather tanned in Saint Louis, Missouri, USA. All leather is oiled with Montana Pitch-Blend Leather Oil and Conditioner.

Coloring: The leather can be left natural in color with an oil finish, or colored with a flat dye color or antique color, a clear protective moisture-resistant finish is applied on both front and back sides. Color Choices: 1) Flat Dyes – Natural, Light Tan, Tan, Saddle Tan (slightly darker than Tan), British Tan (darker than Saddle Tan w/reddish tint), Walnut, Mahogany, Cordovan, Oxblood; 2) Antiques that show off stamping and tooling – Antique Tan, Antique Saddle Tan, Antique Light Brown, Antique Medium Brown, Antique Dark Brown, Antique Mahogany

Widths: Typically 1 ¼” and 1 ½” wide, depending on the design, but can be varied and adjusted depending on the leather ring holder shape and size, ring size, stamping and tooling patterns and edge creasing.  I have made 1 ½” wide hatbands in order to fit stamping and edge creasing.

Edges: Finished with an edging tool, sanded and burnished smooth. Edges can be left plain, or made with a single or double crease. Single or double creased edges are contingent on the stamping pattern or tooling design used and the hatband width.

Rings:  The hatband requires the use of two (2), ½” rings used to tie the cinch knot which secures the hatband. Ring Choices: Solid Brass, Chrome/Brass, Antique Brass, Black Matte/Brass, Nickel/Brass. Dee Rings are also available Nickel Plated, ½” and 3/8″ size.

Leather Ring Holders: Two (2) leather ring holders are each hand cut, skived to shape, folded over, cemented together, stitching groove cut and beveled and tooled if required. The edges are edged with an edging tool, sanded and burnished smooth. The ring holder size and shape may be adjusted. The ring holders are cemented and hand stitched to the hatband at pre-measured and fitted positions. The rings are cinched to each other using a ¼” wide leather tie strap.

To obtain accurate measurement for your hatband, do the following:

• Pull a soft tape measure snugly around the base of the crown (on the outside of the hat) where it meets the brim on your hat. (This is where the hatband sits.)
• This crown-circumferance is used to build the hatband AND to preset the measurement inside the hatband when I ship it to you.
• Your hat size is NOT the measurement we need.